> PRODUCT > HARMOTECH > AMPLIFIERS > M Series

M Series

Ask question about this product

Price : 53000.- บาท


Product Description

HARMOTECH M Series M2 ( 2 Channel )

 

 

     HARMOTECH แบรนด์คุณภาพที่พิถีพิถันเลือกใช้วัสดุอุปกรณ์ระดับสูง เพื่อคุณภาพในการใช้งานและการฟังเพลง ว่ากันถึง เพาเวอร์แอมป์ของแบรนด์นี้ ในรุ่น H Series ที่ได้ผลิตออกมาก่อนหน้านี้ได้เลือกสรรคัดเอาอุปกรณ์ระดับ Hi-END ที่เครื่องเสียงบ้านยังไม่กล้าใช้ พร้อมให้การถ่ายทอดเสียงระดับคุณภาพอุปกรณ์

 

ในรุ่น M Series ล่าสุดนี้ดูจากวงจรแล้ว ไม่ธรรมดาเลยเพราะมีภาควงจรการแยกไฟกระแสสูงและกระแสต่ำ แยกออกจากกัน มีการใช้ทรานซิสเตอร์ภาคขยายส่งต่อกันเป็นทอดๆ ทำให้ได้ความสงัดของเสียงเสมือนดั่งเครื่องเสียงบ้าน

 

รูปลักษณ์ภายนอก

     HARMOTECH M4 เพาเวอร์แอมป์คลาส เอบี 4 Channel ตัวเครื่องหลักใช้อลูมิเนียม มีไททาเนียมและมีช่องระบายความร้อนที่ด้านข้างทั้ง 4 เมื่อพัดลมในตัวเครื่องทำงาน จะมีลมร้อนออกมาจากช่องเเหล่านี้ ปุ่มปรับค่า HPF และ LPF มีมาบอกมาให้ไว้อย่างละเอียด ขั้วสายไฟและสายลำโพงเคลืบด้วยทอง ขั้ว RCA ก็เคลือบทองคุณภาพดีด้วยเช่นกัน

 

รูปลักษณ์ภายใน

     ออกแบบเพื่อการจ่ายกระแสไฟที่ละเอียด ภาคขยายเน้นแบบส่งกำลังภาค่ายไฟ ภาคจ่ายไฟมีขดลวดทองแดงกรองไฟพร้อมกลุ่มคาปาซิเตอร์ ทรานส์ฟอร์เมอร์ขดใหญ่สำหรับจ่ายไฟให้ภาคขยาย ทรานส์ฟอร์เมอร์ขดเล็กสำหรับจ่ายไฟให้ภาคปรีแอมป์ และวงจรในส่วนกระแสต่ำ ภาคขยายใช้ทรานส์ซิสเตอร์ขนาดใหญ่ เพื่อให้มีกำลังขับที่ดี มีรายละเอียด ภาคปรีแอมป์แยก 2 แผงวงจรสำหรับภาคขยายชุดหน้าและหลัง อุปกรณ์ส่วนใหญ่ใช้ SMD เว้นที่กระแสไหลผ่านสูงใช้อุปกรณ์ที่มีขนาดใหญ่ แผ่นวงจรพิมพ์กลาสอีพ็อกซี่คุณภาพสูง

 

ภายในภาคจ่ายไฟมีคุณภาพสูงสามารถจ่ายกระแสให้แต่ละวงจรได้อย่างเต็มอิ่ม มีขดลวดกรองคลื่นรบกวนทำให้เสียงนิ่งขึ้น และการที่ทรานส์ซิสเตอร์ภาคขยายมีหลายขนาดจากเล็กไปใหญ่ช่วยในการส่งกำลัง ให้มีพลังขับที่แรงมีไดนามิคที่ดีและมีรายละเอียด ในด้านพลังขับนั้นหายห่วงสำหรับการขับลำโพงทั้งระบบ แม้ลำโพงจะมีความไวปานกลางก็ตาม เป็นพลังขับที่มีเรียวแรงแข็งขัน เต็มไปด้วยรายละเอียดที่มีบรรยากาศที่สะอาด พลังขับกลมกล่อมที่มีความน่าฟัง มีไดนามิคและความจะแจ้งของรายละเอียดที่ดีมาก

 

- Bias Circuit is tied the temperature of the output to regulate the bias and lower THD at any point in the thermal cycle.  

 

- The preamp stage user X-Drive to increase th output stage effiency. By using a higher voltage of th preamp drives we overcome the terminal loss of the transistors, making the channel operate like the ideal design we see on paper.  

 

- Remote level control selectable for front or rear. Stereo gain controls allow prefect level matching. input mode switch for tonal control of the signal you are sending to the amplifier section.

 

- Input and output filter chokes on the power supply stop any switching noise from entering the amplification stage  

 

- The High voltage power supply is microprocessor controlled to adjjust to different ohm loads. The processor monitors the current at the output and will lower the supply voltage to compensate for lower ohm loads.  

 

- Linear rate transistor heatsink clamps hold the devices with a consistent pressure keeping the heat transfer to the chassis consistent for all the part keeping them as close to the same temperature as possible improves linearity and THD  

 

- 12dB or 24dB Slopes on both highpass and lowpass. Ferquency range for 30Hz - 5500Hz on all crossovers. All Channels are bandpassable. Bass Boost is adjustable for frequency and level.  

 

- Low voltage power supply delivers regulated power to all the low voltage components inth input stage and crossover. By separating the igh voltage and low voltage power supplies we can siignificantly reduce th noise in the input section and improve th overall signal to noise ratio.

 

- Sanken output transistors delivers th output stag. These Darlington outputs are used world wide in the finest audio equipment and have a reputation for low noise and THD.

 

- Speed controlled fan is located at th center of th heatsink consistently cooling the chassis dramatically extending the running time before thermal shut dow.

 

 

 

 

 

Number of channels 2
Amplifier class AB
Output power in 4 ohm 2 x 330 W RMS
Output power in 2 ohm 2 x 650 W RMS
   
Mono bridge mode  
Mono bridge mode 8 ohm 1 x 660 W RMS
Mono bridge mode 4 ohm 1 x 1300 W RMS
Mono bridge mode 2 ohm 1 x 1300 W RMS
   
Frequency Respond 4 Hz - 100 kHz
Crossover Range 30Hz - 550Hz (X10 300Hz - 550Hz)
Bass Boots 0-15dB @ 20Hz - 80Hz
Signal to Noise Ratio (A wtg) Ref Rated Power 4 Ohm > 111dB
Seperation @ 1 kHz > 78dB
Damping (25W 4X4Ohm 100Hz) > 1000
Low Level Input sensitivity 0.3V - 4V
High Level Input sensitivity 0.6V - 8V
Max Peak Current 2Ohm Stereo 222A @ 1800Watts 10% THD+N
Efficiency at rated  2Ohm Stereo 61%
Ldle Current 1.5A
Dimension (W x D x H) 483.8 x 224 x 67.1 mm